CUET Political Science MCQs Unit X Communication Systems

Multiple Choice Questions (MCQs) for CUET Physics: Unit X Communication Systems

Review structured MCQ sets for CUET Physics Unit X Communication Systems. Built according to official CUET guidelines, these downloadable questions support daily revision and core concept reinforcement.

Practice Unit X Communication Systems MCQs for CUET Physics

Navigate directly to the 50 objective questions for Unit X Communication Systems using the digital viewer below. Each practice set includes verified answer keys, allowing students to instantly cross-check their work and identify areas requiring further revision.

Question : During ground wave propagation the transmitted waves gets attenuated because

(a) earth surface absorbs the waves
(b) frequency of the waves are too low
(c) energy content of these waves are high
(d) earth surface offers resistance.

Answer: D 

Question : 12 signals each band limited to 5 kHz are to be transmitted by frequency-division multiplexer. If AM-SSB modulation guard band of 1 kHz is used then the bandwidth of multiplexed signal is

(a) 101 kHz
(b) 99 kHz
(c) 84 kHz
(d) 71 kHz

Answer: D 

Question : Communication is the process of

(a) keeping in touch
(b) exchange information
(c) broad casting
(d) entertainment by electronics

Answer: B

Question : The term channel is used to indicate
(a) the amplitude range allocated to a given source
(b) the frequency range allocated to a given source
(c) the voltage-range allocated to a given source
(d) All of the above

Answer: B

Question :   Wave obtained on superimposition of audible frequency e.m. wave is known as
(a) carrier wave       
(b) high frequency wave
(c) modulating wave
(d) modulated wave

Answer: D 

Question : For a radio wave reaching the ionised medium
(a) will bend away from normal
(b) will bend towards normal
(c) will bend follow a straight-path
(d) None of these.

Answer: A

Question : An audio frequency of 10 kHz is transmitted by SSB after AM with carrier waves of frequency 1MHz. The frequency of current in output load is
(a) 1010 kHz or 990 kHz
(b) 1010 MHz or1010 MHz
(c) 110 kHz or 990 kHz 
(d) 110 MHz or 990 MHz

Answer: A

Question : Television signals are
(a) frequency modulated
(b) amplitude modulated
(c) both frequency and amplitude modulated
(d) phase modulated

Answer: C

Question : A transducer used at the transmitting end, serves the purpose of converting
(a) electrical signal to sound form
(b) sound signal to electrical form
(c) electrical signal to magnetic form
(d) sound signal to magnetic form

Answer: B

Question : The AM wave is equivalent to the summation of
(a) two sinusoidal waves
(b) three sinusoidal waves
(c) four sinusoidal waves
(d) None of these

Answer: B

Question : The service area of space wave communication increases by
(a) increasing the height of transmitting antenna
(b) decreasing the height of receiving antenna
(c) increasing the height of both transmitting and receiving antenna
(d) decreasing the distance between transmitting and  receiving antenna

Answer: C

Question : In FM, when frequency deviation is doubled, then
(a) modulation is halved
(b) carrier swing is halved
(c) modulation is doubled
(d) modulation index is decreased

Answer: C

Question : Which of the following is the element of a communication system?
(a) Transmitter
(b) channel
(c) Receiver     
(d) All of the above

Answer: D 

Question : Which of the following is drawback of amplitude modulation?
(a) low efficiency                 
(b) noise reception
(c) operating range is small
(d) all of these

Answer: D 

Question : In an amplitude modulated wave for audio frequency of 500 cycle/second, the appropriate carrier frquency will be
(a) 50 cycles/s  
(b) 100 cycles/s
(c) 500 cycles/s
(d) 50, 000 cycles/s

Answer: D 

Question : Buffer amplifier is used at the transmitting end to
(a) feed carrier frequency to master oscillator
(b) amplify carrier frequency
(c) mix modulating signal with carrier frequency
(d) isolate master oscillator from other stages of transmitter.

Answer: D 

Question : Audio signal cannot be transmitted because
(a) the signal has more noise
(b) the signal cannot be amplified for distance communication
(c) the transmitting antenna length is very small to design
(d) the transmitting antenna length is very large and impracticable

Answer: D 

Question : In PCM if the transmission path is very long
(a) pulse spacing is reduced
(b) pulse amplitude is increased
(c) pulse width is increased
(d) repeater stations are used.

Answer: D 

Question : As the height of satellite orbit gets lower, the speed of the satellite
(a) increases     
(b) decreases
(c) remain same
(d) both (a) and (b)

Answer: B

Question : To cover a population of 20 lakh, a transmission tower should have a height: (radius of the earth = 6400 km, population per square km = 1000)
(a) 25 m
(b) 50 m
(c) 75 m
(d) 100 m

Answer: B

Free study material for Physics

Download Chapter MCQs: CUET Physics Unit X Communication Systems

About Unit X Communication Systems MCQs for CUET Physics

Test your conceptual understanding of Unit X Communication Systems with these targeted multiple-choice questions. Designed in alignment with the latest CUET curriculum for CUET Physics, these problem sets build accuracy and prepare students for objective exams.

How to Verify Your MCQ Answers

Cross-reference your completed choices with comprehensive NCERT solutions for CUET Physics to ensure absolute clarity across all sub-topics in this chapter.

Enhance Speed with Online MCQ Tests

Follow up your worksheet practice by attempting the interactive online Physics MCQ test for this chapter to evaluate your execution speed. All platform resources are free to access.

FAQs

Where can I access latest CUET Political Science MCQs Unit X Communication Systems?

You can get most exhaustive CUET Political Science MCQs Unit X Communication Systems for free on StudiesToday.com. These MCQs for CUET Physics are updated for the 2026-27 academic session as per CUET examination standards.

Are Assertion-Reasoning and Case-Study MCQs included in the Physics CUET material?

Yes, our CUET Political Science MCQs Unit X Communication Systems include the latest type of questions, such as Assertion-Reasoning and Case-based MCQs. 50% of the CUET paper is now competency-based.

How do practicing Physics MCQs help in scoring full marks in CUET exams?

By solving our CUET Political Science MCQs Unit X Communication Systems, CUET students can improve their accuracy and speed which is important as objective questions provide a chance to secure 100% marks in the Physics.

Do you provide answers and explanations for CUET Political Science MCQs Unit X Communication Systems?

Yes, Physics MCQs for CUET have answer key and brief explanations to help students understand logic behind the correct option as its important for 2026 competency-focused CUET exams.

Can I practice these Physics CUET MCQs online?

Yes, you can also access online interactive tests for CUET Political Science MCQs Unit X Communication Systems on StudiesToday.com as they provide instant answers and score to help you track your progress in Physics.